Installation and operating instructions, ATS022
5.4 Setting the operating modes
5.4.1 Manual mode
To select the Manual operating mode of unit ATS022:
a. Make sure the Power LED is On, see Figure 5.2/1
b. If the Auto LED is OFF, see Figure 5.2/2, the automatic transfer switch is in Manual mode.
c. If the AUTO LED is ON, press RESET, see Figure 5.2/3 . The Auto LED switches to OFF and the
device is in Manual Mode, see Figure 5.2/4 .
1
Figure 5.2:
Description of manual mode selection procedure for ATS022
5.4.2 Automatic mode
To select the Automatic operating mode of unit ATS022:
a. Make sure the Power LED is On, see Figure 5.3/1
b. Press RESET once, see Figure 5.3/2. If the Auto LED is ON, the automatic transfer switch ATS022 is
in Automatic mode, see Figure 5.3/3
c. If the Auto LED is OFF, press RESET again, see Figure 5.3/3; the Auto LED switches to ON and the
device is in Automatic mode/ Figure 5.3/4
1
2
Figure 5.3:
Description of automatic mode selection procedure for ATS022
1SDH000760R0002
2
Manual mode
!
OR
2
3
3
Automatic Mode
!
OR
3
20
5.
Using the automatic transfer switch
4
Manual mode
!
4
5
Automatic Mode
!