Use And Maintain The Illuminator - Welch Allyn KleenSpec 800 Series Directions For Use Manual

Directions for use
Warnings and cautions

Use and maintain the illuminator

Charge the illuminator
Charge the illuminator before using it the first time.
4-5 hr
1. Connect the charging base to AC power.
2. Place the illuminator (either direction) into the charging station.
3. Remove the charged illuminator when you are ready to use it.
Full charging takes 4 to 5 hours.
Note
The charging base has the following status indicators.
WARNING Patient injury risk. No modifications to the illuminator is
allowed. Modification of the illuminator could be hazardous to patients and
personnel.
WARNING Patient injury risk. This device comes with a power supply and/
or power cord that is intended for use only with this device. The power
supply or power cord have not been tested and approved for use with
other devices that may have the same power connectors. If you cannot
locate the original power supply and/or power cord, contact Welch Allyn
Technical Support: www.welchallyn.com/about/company/locations.htm
obtain replacement parts.
WARNING Patient injury risk. KleenSpec Cordless Illumination System is
not suitable for use in the presence of a flammable anesthetic mixture with
air, oxygen, or nitrous oxide. An explosion may result.
CAUTION Disconnect the AC power cord from the charger to the mains
outlet to remove power to the device.
CAUTION The charging station and power cord are not protected from the
ingress of liquid.
CAUTION Do not position any part of the illumination system in any way
that makes it difficult to disconnect AC power from the device. To remove
all AC power from the illumination system, unplug the external power
supply from the mains outlet.
It is safe to leave the illuminator in the charging station after it is charged.
English 3
to