Assembly - Grizzly G0864 Owner's Manual

Assembly

To avoid risk of serious injury, DO NOT con-
nect the sander to power until told to do so
in the Test Run subsection.
The machine must be fully assembled before it
can be operated. Before beginning the assembly
process, refer to Needed for Setup and gather
all listed items. To ensure the assembly process
goes smoothly, first clean any parts that are cov-
ered or coated in heavy-duty rust preventative (if
applicable).
To assemble sander:
1.
Install disc sander table with (2) knob bolts
and (2) 6mm flat washers, as shown in
Figures 6–7.
Mounting
Hole
Knob Bolt w/Flat Washer
Figure 6. Disc sander table pins.
Knob Bolts
w/Washers
Figure 7. Disc sander table attached.
Model G0864 (Mfd. Since 05/19)
Slot
Table Pin
Disc Sander
Table
2. Install belt sander table with (1) lock handle
and (1) 8mm fender washer, as shown in
Figure 8.
Fender
Washer
Figure 8. Belt sander table installed.
3. Slide 1 ⁄ " dust port adapter into existing dust
1
2
port on sanding belt dust cover.
Note: Only the smaller end of the 1
port adapter will fit, as there is a slight taper.
(see Figure 9).
Belt Sander
Dust Port
Dust Port Adapter
Figure 9. Dust port adapter installed.
Belt Sander Table
Lock
Handle
⁄ " dust
1
2
-13-