Position Displacement With A Running Master; Figure 19: Position Displacement - Danfoss VLT 5000 Operating Instructions Manual

Synchronizing controller

Hide thumbs Also See for VLT 5000:

Table of Contents

Position displacement with a running master

If one of the Inputs 32 or 33 is activated during synchronous travel, the actual position in relation

to the master is displaced by the value set in Parameter 742. If the displacement is positive, the

slave accelerates in order to travel the necessary distance in order then again to travel

synchronously to the master at the speed determined via the gear ratio. If the displacement is

negative, the slave decelerates in order to attain the necessary distance to then again travel

synchronously with the master at the speed determined via the gear ratio.

MG.10.N4.02 - VLT is a registered Danfoss trademark

Synchronizing controller

Table of Contents

Show Quick Links

Table of Contents

Do you have a question about the VLT 5000 and is the answer not in the manual?

Vlt 5000 flux