Assembly Instructions - Hotsy 1065SS Operating Instructions And Parts Manual

Unpacking
Unpack carefully. Wear safety glasses or goggles while
unpacking, assembling, or operating pressure washer.
If there are missing components or hidden damage,
immediately contact carrier concerning discrepancies.
1. Cut strapping band from pressure washer and pallet.
2. Remove pressure washer from pallet.
Parts Included
• Pressure Washer
• Pressure Hose
• Wand
• Operating Instructions and Parts Manual
• Gasoline Engine Manual
• Parts Bag Containing:
Pressure Nozzles (3 Ea.)

Trigger Gun

 Battery Terminals (2 Ea.)
Tools Required
• 8" Adjustable Wrench
• Teflon Tape
• Flat Blade Screwdriver
Pressure Hose, Trigger Gun and Wand
1. When assembling, use teflon tape on all threaded
plumbing connections to prevent leakage.
2. Install the pressure hose on the pressure washer as
shown in Figure 1.
3. Assemble wand components as shown in Figure 2.
Relief Valve
Figure 1 - Pressure Hose Installation
8

ASSEMBLY INSTRUCTIONS

Pressure
Hose
HOTSY 965SS-1075SS • 9.807-621.0 • Rev. 09/18
NOTE: The pressure nozzle is not to be installed at
Quick Disconnect
Quick
Disconnect Plug
Pressure
Figure 2 - Wand Assembly
this time.
4. Make sure all plumbing connections are tight.
Battery
WARNING: Wear eye, hand and skin protection when
handling or connecting battery.
WARNING: Batteries generate explosive gases during
normal battery operation.
WARNING: DO NOT expose the battery to flame or
sparks as these gases may ignite.
WARNING: Battery fluid is highly acidic. If battery
fluid contacts skin or clothing, wash immediately
with soap and water. If battery fluid enters eye, im-
mediately flood eye with running cold water for at
least 15 minutes and get immediate medical attention.
1. Electric Start Machines Only: Place battery in bat-
tery box (battery not included). Use a standard 12 volt
automotive battery. Select a battery similar to the one
in Figure 3 for proper fit and installation.
2. I n s t a l l t h e b a t t e r y t e r m i n a l s a s s h ow n i n
8-3/4"
Max
Figure 3 - Battery Dimensions
Wand
Quick
Disconnect
Trigger Gun
Hose
10-1/2"
Max
6-3/4"
Max