Page 1
MODEL 1065A/1065SS OPERATING INSTRUCTIONS AND PARTS MANUAL Read instructions carefully before attempting to assemble, install, operate or service this pressure washer. Failure to comply with instructions could result in personal injury and/or property damage! SPECIFICATIONS Pump Volume At Pump Head: 3.5 GPM/210 GPH Pump Pressure At Pump Head: 3000 PSI Burner Type: Fuel Oil Fired, 314,000 BTU/Hr.
Page 2
Do not operate machine in areas where removed or become damaged they should flammable vapors, (gasoline, solvents, be replaced. Contact your dealer for etc.) may be present, as this machine may replacement decals. ignite the vapors. Page 2 Hotsy 1065A/1065SS...
Page 4
Use a standard 12 volt automotive battery. Select a battery similar to the one in Figure 4 for proper fit and installation. 10-1/2" 8-3/4" RELIEF VALVE 6-3/4" PRESSURE HOSE Figure 4 - Battery Dimensions Figure 2 - Pressure Hose Installation Page 4 Hotsy 1065A/1065SS...
The pressure washer should be sales and service center for details. located to assure easy access for filling of fluids, adjustments and maintenance. Normal precautions should be taken by the operator to prevent moisture from Hotsy 1065A/1065SS Page 5...
MANUAL TRIGGER LOCK operating and safety controls. WARNING: Check hoses, fittings, wand, trigger gun and fuel connections daily for signs of wear, cracks and looseness, and replace as required. Figure 7 - Nozzle Installation/Manual Trigger Lock Page 6 Hotsy 1065A/1065SS...
Page 7
7. Use the width of the spray pattern to wash in a wide setting is reached, the burner will automatically turn path. Overlap spray paths for complete coverage off. washing from side to side, using slow, steady motions. Hotsy 1065A/1065SS Page 7...
Always rinse with cold water after using detergent. Rinse from the top to the bottom to prevent detergent from dripping onto a rinsed area. For the best results, contact your Hotsy dealer to help you select the best detergent for your application. To Stop 1.
Page 9
An optional hour meter (P/N 783865) is available for use Storage for details. on the Model 1065A/1065SS. This hour meter will monitor the total hours of operation of the pressure washer to signal when routine maintenance is required.
Fully open faucet. Check for kinked or damaged hose. Use 5/8 inch minimum hose. Check for debris clogging inlet screen. Trigger of trigger gun released. Squeeze trigger. Water must be spray- ing for burner to light. Page 10 Hotsy 1065A/1065SS...
Page 11
IMPORTANT If the pressure washer demonstrates other symptoms or the corrective actions listed do not correct the problem, contact the local authorized Hotsy Service Center. The Hotsy Service Center can be identified by contacting: Customer Service Department The Hotsy Corporation 21 Inverness Way East •...
Page 12
When ordering from your dealer, please provide the following: Model Number: 1065A/1065SS Machine Serial Number: ________________________________ Component Part Number: _______________________________ Description: __________________________________________ FOR HELP OR ADDITIONAL INFORMATION, CONTACT: Customer Service Department The Hotsy Corporation 21 Inverness Way East Englewood, CO 80112...
Page 15
Fuel Filter NS = Not Shown 698023 Nipple 3/8" x 1/4" Hose Standard hardware item available locally. 698020 Nipple 1/4" x 1/4" Hose 901230 Solenoid Metering Bolt Replacement Parts 615851 Burner 753167 Brush Kit 875490 Filter Element Hotsy 1065A/1065SS Page 15...
Page 16
Control Box Back Standard hardware item available locally. 860140 Isolation Relay Order amount needed in feet. Screw 4 mm x 6 mm Replacement Parts 645990 Bridge Rectifier 676638 Fuse 30A 753134 O-Ring Kit 707146 Fuse Holder 875653 Switch Page 16 Hotsy 1065A/1065SS...
Page 17
875575 Garden Hose Connector Spring 707189 Hose 3/8" x 28" 801126 Garden Hose Connector Order amount needed in feet. 856035 Garden Hose Connector Gasket Replacement Parts 823989 Hose Clamp 961534 Tubing 1/4" 753073 Unloader Repair Kit Hotsy 1065A/1065SS Page 17...
Page 18
Figure 16 - Pump, Exploded View Ref. No. Part No. Description Qty/Pump Ref. No. Part No. Description Qty/Pump 753084 Valve Plug Kit 753079 Oil Seal Kit 753083 Check Valve Kit 753085 Plunger Seal Kit Page 18 Hotsy 1065A/1065SS...
Page 19
Figure 17 - Coil Inlet Assembly Ref. No. Part No. Description Qty. Ref. No. Part No. Description Qty. 698247 Hex Nipple 1/2" x 2" 715755 Coil Drain Plug 754717 Tee 1/2" Hotsy 1065A/1065SS Page 19...
Page 20
Relief Valve Manifold 875555 Relief Valve Seat Screw 4mm x 6 mm 799501 Elbow 1/4" x 3/8" Hose 644802 Street Elbow 3/8" 780565 Copper Washer 630720 Relief Valve Cartridge 915630 Plug 3/8" Standard hardware item available locally. Page 20 Hotsy 1065A/1065SS...
Page 21
Fuel Tank 309294 Nipple 3/8" Hose x 1/4" Hose 817312 Fuel Tank Cap 823988 Hose Clamp 707116 Hose 1/4" (Green) 867368 Hose 1/4" (Black) 661277 Elbow 1/4" Hose x Stand Pipe Order amount needed in feet. Hotsy 1065A/1065SS Page 21...
Hotsy will at its option repair or replace any part covered by this warranty which is defective under normal use for one year at no charge for parts or labor. All defects must be verified by an authorized Hotsy service location.