Page 1
965B, 1075BE, 1080BE Series Hot Water - Gas Engine Operator’s Manual Pressure Washer MODELS: 965B 1.110-565.0 1075BE 1.110-566.0 1075BE CAL 1.110-082.0 1080BE 1.110-567.0 1080BEK 1.110-094.0 For the Hotsy Dealer nearest you, consult our web page at www.hotsy.com 8.931-236.0 - BD 03/01/23...
It contains replacement parts numbers needed for ordering future parts. NOTE: The manual part number is located on the lower right corner of the front cover. Hotsy Gas Belt Drive Series Operator’s Manual 8.931-236.0 - BD...
When ordering parts, please specify model and serial number. Use only identical replacement parts. This machine is to be used only by trained operators. Hotsy Gas Belt Drive Series Operator’s Manual 8.931-236.0 - BD...
THIS EQUIPMENT. make sure the area is dry before ou provoquer l'émission d'autres WHEN OPERATING MACHINE. testing the spark plug or starting the particules dans l'air et leur projection à hautes Hotsy Gas Belt Drive Series Operator’s Manual 8.931-236.0 - BD...
CLEAR OF NOZZLE. placer les mains ou les pieds sur des endroits non isolés de la laveuse à pression. 12. Transport/Repair with fuel tank EMPTY or with fuel shut-off valve OFF. Hotsy Gas Belt Drive Series Operator’s Manual 8.931-236.0 - BD...
The cleaning area should have adequate slopes and drainage to reduce the possibility of a fall due to slippery surfaces. RISK OF INJURY Technical Specifications FROM FALLS WHEN USING LADDER. Hotsy Gas Belt Drive Series Operator’s Manual 8.931-236.0 - BD...
Page 9
Vanguard 16HP 1080BE 555 Lbs 655 Lbs L 42” X W 27.5” X H 39” Karcher V-Twin 1080BEK 590 Lbs 690 Lbs L 42” X W 27.5” X H 39” Hotsy Gas Belt Drive Series Operator’s Manual 8.931-236.0 - BD...
Unloader Valve — Safety device which, when the spray gun closes, prevents over pressurization. Includes safety latch. Wand — Must be connected to the spray gun. Hotsy Gas Belt Drive Series Operator’s Manual 8.931-236.0 - BD...
Proper combus- tion can only be obtained when there is a sufficient supply of oxygen available for the amount of fuel being High Pressure Hose burned. Hotsy Gas Belt Drive Series Operator’s Manual 8.931-236.0 - BD...
84% using #2 Diesel fuel oil. The unit is shipped to a location at 5300 feet altitude with ambient air temperature of 59 °F and a relative humidity of 25%. Cable Hotsy Gas Belt Drive Series Operator’s Manual 8.931-236.0 - BD...
(20 to 100 PSI) water supply, capable of maintaining a minimum of 6.0 GPM. If it is necessary to use a gravity feed water tank, the following plumbing modifications will be required. Hotsy Gas Belt Drive Series Operator’s Manual 8.931-236.0 - BD...
A 1/2” NPT 3-way ball valve will need to be installed in IMPORTANT: If the pressure washer has not been the water inlet line. Hotsy recommends the use of Watts used for an extended period of time, remove the Regulator Valve #1/2 B6780 M1 (Hotsy P/N 921363) for pressure nozzle from the end of the wand and turn this application.
Prepare detergent solution as required by the manufacturer. Fill a container with pressure washer detergent. Place the filter end of detergent suction tube into the detergent container. Hotsy Gas Belt Drive Series Operator’s Manual 8.931-236.0 - BD...
4. Turn key on engine counterclockwise (CCW) to OFF position. 5. Turn OFF fuel shut-off valve. 6. Turn OFF water supply. 7. Squeeze trigger gun open to relieve system pressure. Hotsy Gas Belt Drive Series Operator’s Manual 8.931-236.0 - BD...
The motor bearings are permanently lubricated and will not require any additional lubrication. 4. Clean strainer screen on detergent line periodi- cally. Battery Refer to battery manufacturer’s literature for recom- mended maintenance Hotsy Gas Belt Drive Series Operator’s Manual 8.931-236.0 - BD...
Air bands need to be adjusted Installation. BURNER SMOKES OR HAS Use kerosene, #1 Grade Home Heating Oil, #1 OBNOXIOUS ODOR Improper fuel or #2 Diesel Fuel. DO NOT USE GASOLINE. Hotsy Gas Belt Drive Series Operator’s Manual 8.931-236.0 - BD...
Page 19
Hotsy Service Center. The Hotsy Service Center can be identified by visiting www.hotsy.com. When ordering from your dealer, please provide the following: Model Number: _______________________________________ Machine Serial Number: ________________________________ Component Part Number: _______________________________ Description: __________________________________________ Hotsy Gas Belt Drive Series Operator’s Manual 8.931-236.0 - BD...
Page 20
Notes Hotsy Gas Belt Drive Series Operator’s Manual 8.931-236.0 - BD...
Wiring Diagram -1075BE CAL Hotsy Gas Belt Drive Series Operator’s Manual 8.931-236.0 - BD...
Page 25
Wiring Diagram -1075BE CAL Hotsy Gas Belt Drive Series Operator’s Manual 8.931-236.0 - BD...
Page 26
If you need SERVICE on your pressure washer, contact your local Hotsy dealer or visit www.Hotsy.com. Smart phone users scan the code below to link directly to the Service Request page. To REGISTER your pressure washer, please visit our Warranty Registration page at www.hotsy.com/WarrantyRegistration.aspx or scan the code...