Table of Contents
Advertisement
D I R E C T I O N S F O R U S E
CAUTION
The table weighs as much as
200 lbs. DO NOT lift or move
the unit without using proper
safety procedures or equip-
ment. DO NOT turn the table on
its side for any reason. To do so
could cause damage to the base
and will void the warranty. There
are no serviceable items that
require this
action.
Never lift the table by grasping the
table top as the table top is not
designed to hold the weight of
the base and you could damage
the table.
CAUTION
Before doing any work on the
table, disconnect the power
cord from the power outlet and
secure the electrical cord, and
foot controls for moving.
14
M O V I N G T H E T A B L E
at low height range
The table weighs approximately 200 lbs. You will need 4 people working
together to move the table. Never lift the table by grasping the table top
as the table top is not designed to hold the weight of the base and you
could damage the table and the electronics that operate the tabletop.
If you need to move the table, place one person at each corner of the
table. Have each person firmly grasp the metal leg at the bottom and lift
the table from the base. As when moving any piece of heavy equipment,
bend at the knee and lift with your legs beneath you and not with your
back. Be aware and use proper, safe procedures for moving a table of
this size to prevent injury to yourself or the table. We strongly recommend
that a flatbed dolly be used that can hold the entire table if moving the
table involves a longer distance.
T R O U B L E S H O O T I N G
I F T H E T A B L E W I L L N O T C H A N G E H E I G H T O R P O S I T I O N
(E L E C T R I C/H Y D R A U L I C M O D E L):
•
Check that the keyswitch on the shelf is in the "on" position.
•
Check the outlet to be sure that it has power and that the power cable is plugged
in. Try each Foot Control and Hand Control to see if any work. If any work, then
possibly there is a loose connection or a faulty controller.
•
Unplug the power cable from the wall outlet.
•
Make sure that all male and female connectors are firmly pushed into each other.
Even a slight misconnection can cause a possible malfunction.
•
Plug the unit back into the wall and check the controls again. If one or more of
the controls still do not work, contact Customer Service at 800-558-8850.
I F T H E T A B L E I S M A K I N G N O I S E D U R I N G H E I G H T A D J U S T M E N T:
•
If you hear squealing or a pop during the height adjustment, this may be related
to lack of lubrication in the hydraulic cylinders. We recommend that you imme-
diately cycle the table fully up/down at least seven times. If this does not work,
then let the motor cool down for at least two hours and repeat the procedure.
The table should return to its normal quiet mode. Refer to "DIRECTIONS FOR
USE; Daily Cycling."
Grasp
at base
corner
Advertisement
Table of Contents
