Adjusting The Top - OAKWORKS Clinician User Manual

D I R E C T I O N S F O R U S E
When operating the table's controls
be sure to observe all cautions and
warnings given in the manual to
prevent injury to both operator and
client.
CAUTION
Do not sit on the elevated
Back Rest or Leg Rest.
Back Rest Lever
Leg Rest
Adjustment Lever
10
O P E R A T I N G T H E M A N U A L T O P (I F E Q U I P P E D)
BACK REST
To Raise the Back Rest:
section and lifting up to the desired height. It is recommended that clients take some of
their weight off the back rest while you lift.
To Lower the Back Rest:
rest down. Release the lever and the back rest will stay in place.
To Change Position of the Back Rest Lever:
to the opposite side of the back rest by removing the screws and relocating the hand
lever to the opposite side of the top into the four pre-drilled holes. See Back Rest Lever
photo at left for screw locations
LEG REST
The leg rest adjustment lever is located on the side of the table under the seat section
To Change the Lever Position:
screws. Move handle to the opposite side of the table. Remove the screws that are there
and mount the lever. See Leg Rest Adjustment Lever photo at left for screw location.
To Raise the Leg Rest:
the leg rest by pulling the lever on
the side of the seat section and raise
to the desired height with your other
hand as shown. To make the adjust-
ment easier, it is recommended that
clients take some of their weight off
the leg rest while you lift.
Back Rest
Control
Raise the back rest by pressing the lever under the head
Press the lever under the head section and push the back
The back rest lever can be moved
Remove the screws from the lever and replace just the
To Lower the Leg Rest:
Raise
lever on the side of the seat section
and push the leg section down as
shown. It is recommended that this be
done with the client on the table as this
weight will assist in lowering the leg
section. Release the handle once leg
rest is at desired location and the leg
section will stay in place.
.
Pull the