Grounding Instructions - OAKWORKS Clinician User Manual

READ AND
SAVE THESE
INSTRUCTIONS
CAUTIONS
W A R N I N G S & S A F E T Y I N S T R U C T I O N S (C O N T I N U E D)
W A R N I N G S & S A F E T Y I N S T R U C T I O N S
To remove the accessories from the shelf: Turn the accessory controls
to the off position and then disconnect the unit from the interior power
source by removing the plug from the outlet.
When moving the table: Turn the accessory controls to their off position,
disconnect the table from the exterior power source by removing the
table plug from the outlet.
G R O U N D I N G I N S T R U C T I O N S
This product must be grounded. If it should malfunction or break down,
grounding provides a path of least resistance for electrical current to reduce
the risk of electric shock. This product is equipped with a cord having an
equipment-grounding conductor and a grounding plug. The plug must be
plugged into an appropriate outlet that is properly installed and grounded in
accordance with all local codes and ordinances. See U.S. example below.
This product is manufactured for use on a nominal 120-volt circuit for the
United States and a nominal 220-volt circuit for use in Europe. The plug has
a grounding pin in a pattern that varies by country as shown in the Product
Identification section of this manual. Make sure that the product is connected
to an outlet having the same configuration as the plug.
Correct Implementation
DANGER-
Improper connection of the equipment-grounding conductor
can result in a risk of electric shock. Check with a qualified electrician
or service man if you are in doubt as to whether the product is properly
grounded. Do not modify the plug provided with the product - if it will not fit
the outlet, have a proper outlet installed by a qualified electrician.
To reduce the risk of electric shock, this furnishing has a polarized plug.
This plug will fit in a polarized outlet only one way. If the plug does not fit
fully in the outlet, reverse the plug. If it still does not fit, contact a qualified
electrician to install the proper outlet. Do not change the plug in any way.
No adapter should be used with this product.
G R O U N D I N G I N S T R U C T I O N S
(E L E C T R I C M O D E L O N L Y)
Incorrect Implementation
5