4.1
Start
NOTE!
It is advised to set the „Speed set value positive limit" on beginning to zero, to pre-
vent any damage on the servo pump.
Figure 31:
h Click on „Continue"
h If known, set the load inertia.
Figure 32:
h Click on „Continue"
34
Application handbook Servo pump function V1 for BM5000
Document No.: 5.17002.02
of 76
Guided commissioning: Essential parameter settings
Set the controller settings to „hard".
The controller calculates the Kp, Tn and Ks values which can be accepted by clicking
on „Download data".
Guided commissioning: Speed controller parameters
Baumüller Nürnberg GmbH