Controller Address Setting - Newport SMC100CC Manual
Single-axis motion controller/driver for dc or stepper motor
Hide thumbs
Also See for SMC100CC:
- User manual (86 pages) ,
- Manual (62 pages) ,
- Command interface manual (40 pages)
Table of Contents
Advertisement
SMC100CC & SMC100PP
Controller GUI Manual
4.6.2
Controller address setting
This part allows the user to configure the RS485 address of the FIRST controller.
"Set" button
Select a controller address from the list and press the "Set" button. A progress bar is
displayed during the address configuration.
It is recommended to note the address of the controller somewhere. For example, use
the stickers supplied with the SMC100CC/PP.
Now disconnect this controller from your PC and connect the next one instead. Select a
new, not yet allocated address and press the "Set" button again (proceed the same with
all other controllers).
17
EDH0310En1030 – 01/17
Advertisement
Table of Contents
