Newport SMC100CC Manual page 13

SMC100CC & SMC100PP
"Incremental Motion / PR-Move Relative"
In the "Incremental Motion / PR-Move Relative" area, two increment values can be
defined. For each defined increment, a relative move is preformed in either the negative
direction or positive direction.
"Cyclic Motion" and "Target position / PA-Move Absolute"
In the "Cyclic Motion" area, a motion cycle is configured with a number of cycles
(Cycle) and a dwell time in milliseconds. The motion cycle gets the defined target
positions from the "Target position / PA-Move Absolute' area to perform the cycle.
Tempo (Dwell)
Tempo (Dwell)
Tempo (Dwell)
Tempo (Dwell)
In the "Target position / PA-Move Absolute" area, two target positions can be defined.
The "Go to" button executes the absolute move to the specified target position.
"Motion Configuration Values"
In the "Motion Configuration Values", the current ends of run and the velocity are
displayed in a disabled text box: "Minimum end of run", "Maximum end of run" and
"Velocity". These ends of run and the velocity can be modified and saved with the
"Set" button.
Memorized positions
The combo box allows memorizing the positions by the "Save Pos." button. Each of
these positions can be renamed or deleted. To execute an absolute move to one of these
memorized positions, select one item of the combo box and click on the "Go to" button.
When the mouse hovers over the combo box, the selected memorized position is shown
in an information balloon.
Rename a memorized position: Select an item from the combo box, edit the position
name and click on the "Rename" button to save the new position name.
Delete a memorized position: Select an item from the combo box, right-click on the
mouse and select the "Delete" to delete the selected memorized position.
9
Target #1
Controller GUI Manual
Target #2
Loop #1
Loop #2
Loop #N
EDH0310En1030 – 01/17