Installation; Install Smc100 Graphical User Interface; Launch Gui - Newport SMC100CC Manual
Single-axis motion controller/driver for dc or stepper motor
Hide thumbs
Also See for SMC100CC:
- User manual (86 pages) ,
- Manual (62 pages) ,
- Command interface manual (40 pages)
Table of Contents
Advertisement
SMC100CC & SMC100PP
2.0
Installation
EDH0310En1030 – 01/17
2.1
Install SMC100 Graphical User Interface
Following are steps to install SMC100 GUI:
• For 32 bit, Select and launch "SMC100 Utility Installer Win32.exe". For 64 bit,
Select and launch " SMC100 Utility Installer Win64.exe".
• A window opens up showing Install welcome page.
• Click on "Next".
• A window opens up allowing destination folder selection. By default it is showing
C:\.
• Click on "Next".
• Ready to install window opens up. Click "Install".
• Then installation starts, wait for completion. Click on "Finish" to finalize the
installation.
32 bit installer will be installed "Newport.SMC100.CommandInterface.dll" in GAC_32
folder and 64 bit installer will be installed the dll in GAC_64 folder.
LabVIEW user can add reference of command interface dll from GAC during VI
creation.
2.2
Launch GUI
From Windows "START" menu , select "All Programs\Newport\Motion
Control\SMC100\SMC100 Utility".
NOTE
4
Controller GUI Manual
Advertisement
Table of Contents
