Assembly Of The Tail Unit/Adjustment Of The Linkage Rods - ROBBE Arcus II Series Instruction And User's Manual

Assembly
1.

Assembly of the tail unit/adjustment of the linkage rods

7
Pictures 7 and 8:
Put all servos in neutral position. All control surfaces must be in neutral position as well.
If necessary, turn the clevises until the correct length is reached on the booms.
Note:
This is a schematic diagram for adjusting the rudders.
It is only for orientation on how to adjust the rudders correctly and may not represent the scope of supply or
equipment of the model supplied.
8
I N S T R U C T I O N S A N D U S E R M A N U A L
8
9
Picture 9:
Tighten the clevis screws only moderately so that the linkage
moves smoothly.
Note:
This illustration only applies if clevis are used on the model
which are attached to the horn by means of screws.