Page 2
FUTABA Transmitter Ready, abbreviated to FTR, applies to fixed-wing model aircraft and helicopters from the robbe range whose receivers work with the FUTABA S-FHSS code, which means that they can be bound to FUTABA transmitters which can be operated in S-FHSS mode.
Operating Instructions - BLUE ARROW Trainer CP S-FHSS RTB 2.4 GHz No. S2537 Be sure to read these Safety Notes before you assemble your Please bear in mind that motors and speed controllers model. Always keep to the procedures and settings recom- may become hot when operating.
Page 5
Operating Instructions - BLUE ARROW Trainer CP S-FHSS RTB 2.4 GHz No. S2537 Use only those components and accessories which we specifically Insurance recommend. Ground-based models are usually covered by standard personal third-party insurance policies. In order to fly model aircraft you will...
Page 6
Operating Instructions - BLUE ARROW Trainer CP S-FHSS RTB 2.4 GHz No. S2537 Dear customer, Congratulations on choosing a factory-assembled mo- del helicopter from our range. Many thanks for placing your trust in us. The model can be completed and prepared for flight very quickly.
Operating Instructions - BLUE ARROW Trainer CP S-FHSS RTB 2.4 GHz No. S2537 Model description: Please note the following points in order to avoid confusion 1. Latest generation of six-axis gyro system with improved re- in the model description: sponse, ensuring stable, accurate flight.
Operating Instructions - BLUE ARROW Trainer CP S-FHSS RTB 2.4 GHz No. S2537 A = Main motor connectors Battery connector: B = Tail rotor motor connectors C = S-FHSS module D = Binding button Disconnect the main and tail rotor...
Operating Instructions - BLUE ARROW Trainer CP S-FHSS RTB 2.4 GHz No. S2537 Trouble-shooting if the receiver LED flashes when switched on: Possible causes Solutions Binding failed Switch the radio control transmitter and receiver off. Now switch the transmitter on again, and switch on the receiver power supply.
Page 11
Operating Instructions - BLUE ARROW Trainer CP S-FHSS RTB 2.4 GHz No. S2537 Adjusting tail rotor gyro gain: Mode Manual - To adjust the gain of the tail rotor gyro please follow the description in the instructions Switch MIX SW supplied with your T8J radio control system (8.5 Gyro (gyro gain), page 44)
Operating Instructions - BLUE ARROW Trainer CP S-FHSS RTB 2.4 GHz No. S2537 Pre-flight adjustments: Caution: disconnect both motor wires from the speed controller to avoid the motor bursting into life unexpectedly, as this could cau- se injury. Please note: all the model's components are correctly adjusted at the factory, and no adjustments are normally required.
Operating Instructions - BLUE ARROW Trainer CP S-FHSS RTB 2.4 GHz No. S2537 Adjusting the swashplate Caution: disconnect both motor wires from the speed controller to avoid the motor bursting into life unexpectedly, as this could cause in- jury. At half-throttle (throttle stick central) the servo output arms must be horizontal (parallel to the servo case), and the swashplate should be in the centre of the collective pitch travel.
Page 14
Operating Instructions - BLUE ARROW Trainer CP S-FHSS RTB 2.4 GHz No. S2537 Checking blade tracking The following section describes the main causes for incorrect Please note: to avoid accidents, place the helicopter at least blade tracking: three metres from you for checking blade tracking. Slowly advan- 1.
Operating Instructions - BLUE ARROW Trainer CP S-FHSS RTB 2.4 GHz No. S2537 These points must be checked before flying: Important notes: - Before flying the model check that the receiver battery is fully Take-off: raise the rotor speed slowly and steadily until the model charged, and that the transmitter batteries still have adequate hovers at eye-level.
Page 16
Operating Instructions - BLUE ARROW Trainer CP S-FHSS RTB 2.4 GHz No. S2537 Controlling the model in Mode 1 (throttle right) Controlling the model in Mode 2 (throttle left) Roll: Roll: If you move the roll stick If you move the roll stick...
Page 17
Operating Instructions - BLUE ARROW Trainer CP S-FHSS RTB 2.4 GHz No. S2537 Fine adjustments during the first flight: Mechanical fine-tuning: - If the model drifts in one direction when hovering, either in the roll (left / right) or pitch (forward / back) axis, adjust the swashplate by shortening / lengthening the pushrods until the drift ceases.
Operating Instructions - BLUE ARROW Trainer CP S-FHSS RTB 2.4 GHz No. S2537 Flight practice for the beginner Please note: 1. Beginners should always ask an experienced helicopter pilot for help. 2. To avoid accidents, beginners should always stand at least five metres away from the model when practice-flying.
Operating Instructions - BLUE ARROW Trainer CP S-FHSS RTB 2.4 GHz No. S2537 4. Flying circuits Mode 1 Mode 2 When you feel confident with steps (1) – (3), it is time to move on to the first circuits. Please bear in mind that the roll and pitch-axis control functions are effectively reversed when the model is flying towards you.
Page 20
Operating Instructions - BLUE ARROW Trainer CP S-FHSS RTB 2.4 GHz No. S2537 4. Flying figures-of-eight When you have mastered all the steps outlined above, it is time to attempt a figure-of-eight. Please note that the pitch-axis and roll func- tions are effectively reversed when the model is flying towards you.
Page 21
Operating Instructions - BLUE ARROW Trainer CP S-FHSS RTB 2.4 GHz No. S2537 3D flying in Mode 1 (throttle right) 3D flying in Mode 2 (throttle left) When you move the roll When you move the roll stick to left or right, the...
Operating Instructions - BLUE ARROW Trainer CP S-FHSS RTB 2.4 GHz No. S2537 robbe Modellsport GmbH & Co. KG hereby declares that this device conforms to the fundamental requirements and other re- levant regulations of the corresponding EC Directive. You can read the original Conformity Declaration on the Internet at www.
Page 24
Modellsport Beteiligungs GmbH Gießen / HRB 5793 Managing Director: E. Dörr Errors and technical modifications reserved. - Copyright robbe-Modellsport 2013 Duplication and copying of the text, in whole or in part, is only permitted with the prior written approval of robbe-Modellsport GmbH & Co. KG...
Need help?
Do you have a question about the BLUE ARROW and is the answer not in the manual?
Questions and answers