ROBBE ARCUS SONIC RTF Operating Instructions Manual

ROBBE ARCUS SONIC RTF Operating Instructions Manual

2.4 ghz

Advertisement

Operating Instructions
ARCUS SONIC
RTF
2.4 GHz
No. 2565

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the ARCUS SONIC RTF and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for ROBBE ARCUS SONIC RTF

  • Page 1 Operating Instructions ARCUS SONIC 2.4 GHz No. 2565...
  • Page 2: Operating Instructions - Arcus Sonic Rtf 2.4 Ghz No

    Operating instructions - ARCUS SONIC RTF 2.4 GHz No. 2565...
  • Page 3: Table Of Contents

    Operating instructions - ARCUS SONIC RTF 2.4 GHz No. 2565 Explanation of specialist terms: Contents Page Explanation of specialist terms / Contents Motor speed ("Throttle"): This controls the rotati- Safety Notes 4, 5 onal speed of the motor. Stick forward = maximum Set contents / Specification / Recommended accessories speed;...
  • Page 4: Safety Notes

    Operating instructions - ARCUS SONIC RTF 2.4 GHz No. 2565 Do not stand close to the hazard area around rotating parts when Be sure to read these Safety Notes before you assemble your mo- del. Always keep to the procedures and settings recommended in an electric motor is connected to the flight battery.
  • Page 5 Do not carry out modifications to the radio control system components Liability Exclusion apart from those described in the instructions. robbe Modellsport is unable to ensure that you observe the assembly and operating instructions, or the conditions and methods used for installing, Operating the model operating and maintaining the model components.
  • Page 6: Set Contents / Specification / Recommended Accessories Assembling The Model Charging The Flight Battery / Lipo Battery Safety Notes Summary Of Transmitter Settings In Mode 1 Und Mode

    Operating instructions - ARCUS SONIC RTF 2.4 GHz No. 2565 Dear customer, Congratulations on choosing a model aircraft from our ran- ge. Many thanks for placing your trust in us. The model can be completed and made ready to fly very quickly.
  • Page 7 Operating instructions - ARCUS SONIC RTF 2.4 GHz No. 2565 Assembling the model Fit the tailplane into the slot in the fin from the left-hand side using only Fig. 4 Fig. 5 moderate pressure, until it is positioned flush with Slide the wing joiner spar into the right-hand wing panel the fuselage (Fig.
  • Page 8 Operating instructions - ARCUS SONIC RTF 2.4 GHz No. 2565 Using the charger to charge the flight battery Safety Notes regarding LiPo batteries: • Do not place the battery in water or any other liquid. The battery charger must be connected to a 12 V power • Do not heat or incinerate the battery; do not place it source with a minimum output power of 2 A using the con- in a microwave oven.
  • Page 9: Transmitter Settings In Mode

    Dual-Rate status indicator Dual-Rate status indicator Also: Status indicator for the individual trim settings Also: Status indicator for the individual trim settings (Complete operating instructions for the J5 transmitter can be found in the Download area at www.robbe.com)
  • Page 10 Operating instructions - ARCUS SONIC RTF 2.4 GHz No. 2565 "Primary" and "expanded" control function setting Converting the transmitter from "Mode 2" (throttle left) to "Mode 1" (throttle right) The transmitter offers the facility to adjust the sensitivity of the stick movements. We recommend "softer" reduced travels for beginners.
  • Page 11 Operating instructions - ARCUS SONIC RTF 2.4 GHz No. 2565 Transmitter settings Mode 1 Throttle trim: If the propeller starts to move without you touching the throttle stick, or does not respond to stick movements, cor- rect this with the throttle trim.
  • Page 12 Operating instructions - ARCUS SONIC RTF 2.4 GHz No. 2565 Transmitter settings, Mode 2 Throttle trim: If the propeller starts to move without you touching the throttle stick, or does not respond to stick movements, cor- rect this with the throttle trim.
  • Page 13: Flight Preparation

    Operating instructions - ARCUS SONIC RTF 2.4 GHz No. 2565 Flight preparation The correct pre-flight procedure. Switch the transmitter on (Fig. 1).The battery status is displayed at the top of the screen. Move the throttle stick and trim to the lowest position. Open the canopy, place the fully charged LiPo flight battery in the recess, and use the Velcro tape to hold it in place.
  • Page 14: Controlling The Model

    Operating instructions - ARCUS SONIC RTF 2.4 GHz No. 2565 Controlling the model in Mode 1 Controlling the model in Mode 2 High RPM (launch): Motor off (landing): High RPM (launch): Motor off (landing): Right turn: Right turn: Left turn:...
  • Page 15: Important Notes

    Operating instructions - ARCUS SONIC RTF 2.4 GHz No. 2565 Important Notes The first few flights Launching: Hold the model in your hand, set the motor to full power, and push the model forward smartly, directly into any wind. It is essential to adjust the trims so that the aeroplane flies in a stable attitude, climbing smoothly.
  • Page 16: Re-Binding The Transmitter

    Operating instructions - ARCUS SONIC RTF 2.4 GHz No. 2565 Re-binding the transmitter This procedure is only necessary if individual components are replaced. Move the throttle stick and trim to the bottom position (motor stopped), then place the transmitter as close as possible to the receiver.
  • Page 17: Protective Function Of The Bl Speed Controller

    Operating instructions - ARCUS SONIC RTF 2.4 GHz No. 2565 Protective function of the BL speed controller with the Airbrake setting battery connected: In the default setting the airbrakes (ailerons) extend down- If the flight battery is connected to the Arcus-Sonic's BL con- ward.
  • Page 18: Replacement Parts List

    Operating instructions - ARCUS SONIC RTF 2.4 GHz No. 2565 25650001 25650002 25650003 2565004 NE200105 NE200106 Replacement parts list - ARCUS SONIC RTF Order No. Description 25650001 Fuselage 25650002 Tail set 25650003 Wing 25650004 Propeller set 25650005 Decal sheet (not shown)
  • Page 19 Modellsport GmbH & Co. KG hereby declares that this device conforms to the fundamental requirements and other relevant regulations of the appropriate CE Directive. Under www.robbe.com, you will find the original Conformity Declaration by clicking on the Logo button "Conform" shown together with the appropriate device description.
  • Page 20 Modellsport Beteiligungs GmbH Gießen / HRB 5793 · Managing Directors: G. Geiger, E. Dörr Errors and technical modifications reserved. · Copyright robbe-Modellsport 2011 Duplication and copying of the text, in whole or in part, is only permitted with the prior written approval of robbe-Modellsport GmbH & Co. KG...

This manual is also suitable for:

2565

Table of Contents