Vibration Analysis - JETI model Duplex REX Assist Series User Manual

computer radio control system
the receiver in a new model for the first time:
In the receiver menu, view Telemetry -> Sensor Calibration screen.
Activate the "Start calibration" command and follow the
instructions. The receiver must be placed on a horizontal board
with one of its six sides and kept still for about 2 seconds. Once the
position is correctly recorded, the "Remaining positions" line is
decremented - at this time rotate the receiver and place it on the
board by another side. Repeat until the number of remaining
positions is greater than zero.
After completing the calibration, please make sure that the total G-
Force displayed on the Telemetry screen lies in the range of 0.99 -
1.01G (measured at rest).

5.8 Vibration analysis

Vi b rat i o n s a re a n u n d e s i ra b l e
phenomenon for any stabilization
system, as it adds unwanted noise into
measurement. In the receiver menu,
you can display a graph showing the
actual vibration level. It's measured
using frequency analysis in the
selected accelerometer axis.
The receiver itself contains effective algorithms to suppress the
www.modellmarkt www.modellmarkt
vibrations (see Configuration -> Advanced Properties), but the
cost is a relative reduction of the model's preciseness and
43
EN