Multicopter - JETI model Duplex REX Assist Series User Manual

computer radio control system

4.2 Multicopter

Before you connect and configure the REX A receiver for the first
time in a multicopter model, we recommend disconnecting speed
controllers with motors from the receiver to avoid accidental
spinning.
1. Remove the propellers from motors.
2. Place the receiver in the model according to the Installation in
the model chapter.
3. In the transmitter, create a new multicopter model. When
setting up, make sure that Motor/Throttle, Aileron/Roll,
Elevator/Pitch, Rudder/Yaw and Flight-Mode switching
functions are operated separately on each channel.
4. Pair the transmitter with the receiver.
5. Navigate to the receiver settings either via the DC/DS menu
(Model -> Device Explorer) or via USB adapter and JETI Studio.
6. Run the stabilization setup wizard
Wizard). On the first screen, enter the "Multicopter Assist"
option.
a)
www.modellmarkt www.modellmarkt
b) (Configuration -> Quick
b)
21
EN
a)