Device Dmx Start Address Selection; Display - Terbly TP02-CW User Manual

8. DEVICE DMX START ADDRESS SELECTION

All fixtures should be given a DMX starting address when using a DMX signal, so that the
correct fixture responds to the correct control signals. This digital starting address is the channel
number from which the fixture starts to "listen" to the digital control information sent out from
the DMX controller. The allocation of this starting address is achieved by setting the correct
address number on the display located on the base of the device.
You can set the same starting address for all fixtures or a group of fixtures, or set different
addresses for each fixture individually.
If you set the same address on all devices, all the devices will start to "listen" to the same control
signal from the same channel number. In other words, changing the settings of one channel will
affect all the fixtures simultaneously.
If you set a different address, each unit will start to "listen" to the channel number you have set,
based on the quantity of control channels of the unit. That means changing the settings of one
channel will affect only the selected device.
In the case of this device, which utilizes 1 channels, you should set the starting address of the first
unit to 1, the second unit to 2 (1 + 1), the third unit to 3 (1+ 2), and so on.

9. DISPLAY

The Display offers several features: you can set the starting address, run the pre-programmed
program or reset the device.
The main menu is accessed by pressing the
through the menu by pressing the
Press the Enter-button in order to select the desired menu. You can change the selection by
pressing the -button ,
by pressing the
accessing the edit mode, the unit will automatically exit to the main menu after 15 seconds from
the last button press. When the unit is powered on, if no data signal is connectedafter 1 minute,
then the display will switch off automatically. The Display does not need external power to
operate. Hold down the
unit's battery built in battery.
Set Dmx Address
Dmx Value
Time Information
Temperature Info
Software Version
TP02-CW,WW User Manual
-button ,
-button ,
-button. You can leave every mode by pressing the
-button for 3 seconds and the Display will turn on by using the
A001~AXXX
ALL......
Current Time
Total Run Time
Last Run Time
LastRun Password
Clear Last Run
Head Temp
Vx.x.x...
-button until the display starts flashing. Browse
-button ,
-button or -button. Confirm every selection
XXXX(Hours)
XXXX(Hours)
XXXX(Hours)
Password=XXX
ON/OFF
XXX℃/℉
11
-button or -button.
-button. After
DMX address setting
DMX value display
Power on running time
Fixture running time
Fixture Last times clear
Timer Password 038
Clear Fixture Last time
Temperature in the head
Software version
XM1268/1257-V1.0-NR