Rack Mounting Procedure - Sony HDS-X5800 Installation Manual

1-5-2. Rack Mounting Procedure

This section describes the rack mounting procedure using
the rack mount kit supplied with the HDS-X5800.
n
Tighten the screws to the following torque.
Tightening torque : 120 x 10
1. Attach the bracket to the support angle tentatively
using the specified four screws.
2. Loosen the front and rear screws that are tentatively
fastened in step 1. Adjust the length of the brackets
according to the depth of the rack.
(The illustration below shows the left bracket.)
Support angle
PSW4 x 10
Bracket
n
Maximum depth of bracket : 750 mm
Minimum depth of bracket : 595 mm
HDS-X5800
_2
N.m {12.2 kgf.cm}
Bracket
PSW4 x 10
3. Attach the right and left brackets to the rack complete-
ly using the specified eight screws.
(The illustration below shows the left bracket.)
Front side
Rack
B4 x 10
Rear side
Bracket
31.75
4. Tighten the screws (four screws each on the right and
left) for adjusting the length of the bracket completely
(the screws that were loosened in step 2).
5. Place the right and left ends of the bottom of the HDS-
X5800 on top of the support angles, and slide the
equipment to the rear.
n
The support angles support the bottom of the HDS-
X5800 as shown below.
Bracket Support angles
1-5. Rack Mounting
Bracket
31.75
Rack
Unit : mm
B4 x 10
Bracket
1-5 (E)