Downloading Data - Sony HDS-X5800 Installation Manual

2-6. Data Backup

2-6-4. Downloading Data

Downloads the various setup data that are saved in a PC, to the system equipment through primary
station.
1. Install the BZR-20 software. (Refer to Section 2-6-2.)
2. Connect the PC to the HDS-X5800 (or connect the PC to each equipment) and start up the BZR-20
software. (Refer to Section 2-6-3, steps 2 to 5.)
3. Select a desired folder (the folder in the hard disk or FD drive) in which the setup data are saved,
from the File (F) menu of the menu bar. Press [OK].
n
You cannot create a new folder at this step.
4. Select the desired button from "SEND: PRIMARY to PRIMARY" column that suits to the contents
of the downloaded data and press the button.
[DescriptionF5] : It downloads the names of the total 2048 connectors of the SOURCE (input) and
DESTINATION (output) that are stored in the PC.
[CrosspointF6] : It downloads the latest cross-point data (1024 sources and 1024 destinations,
level: 8) that are saved in the PC.
[PrimaryF7] :
It returns the setup data of the primary station to the original state.
(The data as the secondary station that are stored in the primary station are also
returned to the original state.)
n
The name of the connector and the cross-point data are not downloaded.
[SecondaryF8] : It downloads the setup data of the secondary equipment that is connected to the
S-BUS remote. Either all of the setup data that are stored in the specified folder,
or any single specified secondary station can be selected for downloading.
Press Cancel (C) to stop downloading.
5. When downloading is completed, press Exit (E) and close the BZR-20 window.
2-16 (E)
HDS-X5800