Chattanooga Revolution Wireless User Manual page 84

8 2 R E V O L U T I O N W I R E L E S S ™
1 0 . e M c t a B l e S
re cO MMeNdati ONS aN d dec l arat iO N By tH e Ma NuFact urer
cONcer N iNG el ectrOMaG Neti c i MMuN i ty
Device is designed for use in the electromagnetic environment stipulated below. The buyer or user of
the device must ensure it is used in this recommended environment.
test
imm u ni ty
level i e c
t e st
60601
3 Vrms
Conducted RF
150 kHz to
IEC 61000-4-6
80 MHz
3 V/m
Radiated RF
80 MHz to
IEC 61000-4-3
2.5 GHz
Obse r va nc e ele c tromagnetic en vironmen t -
leve l re c o mmend ati ons
Portable and mobile RF communication devices must
only be used relative to the device and its wiring
3 Vrms at a distance which is not less than the spacing
150 kHz to 80 recommended and calculated using the appropriate
MHz equation for the transmitter's frequency.
recommended spacing
d = 1.2 √P
d = 1.2 √P 80 MHz to 800 MHz
d = 2.3 √P 800 MHz to 2.5 GHz
The Revolution Wireless device may be susceptible to
Radiated RF energy at and greater than 10V/m.
In the event of such exposure, the device may
3 V/m
experience communication loss between remote and
modules. The device will terminate all active outputs,
automatically place the device in a safe state.
To recover from this, turn remote and all modules
off and turn them on after 5 sec delay using on/off
switch on each. Once the device restarts, re-initiate
all treatments.
where P is the maximum output power of the
transmitter in watts (W) set by the manufacturer's
specifications and where d is the recommended
spacing in metres (m). The field intensity of RF fixed
transmitters, as determined by an electromagnetic
survey a must be less than the observance level to
be found in each frequency range
may occur close to any appliance identified by the
following symbol:
20xx
. Interference
b
E N