Advertisement
Chapter2 System installation
This chapter provides a brief guidance on how to install the SUPERPRO software and
connect the programmer hardware properly.
NOTE: To avoid complications during the installation process, you must setup the
software before connecting the programming hardware (the USB device) to your
computer. That is, installation through the "Add New Hardware Wizard" of Windows
system is NOT recommended (this might lead to wrong drivers with a different
compatible device ID).
2.1 Software Setup
Select the software to setup your SUPERPRO programmer either from the CD‐ROM
or by downloading the program from the Xeltek website. Instructions for both methods
are described below.
2.1.1 Software setup from CD
1. Insert the CD into the CD-ROM drive.
2. If the setup program does not start automatically, run SETUP.EXE located in
the root directory.
3. Select the appropriate programmer model.
4. Click Setup.
NOTE: Each model has its own software and they are NOT compatible.
2.1.2 Download the software from website and setup (recommended)
You can also download the specific software for a certain model at Xeltek website:
http://www.xeltek.com.
programmer. Once you have saved the file to your computer, run it to setup the
software. The following procedure describes the setup process step by step.
Select the icon to download the appropriate file for your
7 / 56
Advertisement
