Advertisement
connected improperly. Check the connection.
•
Programmer not ready: Turn off the programmer power switch and turn it
on again after a few seconds.
•
Programmer is running: The programmer hardware is operating. Wait until
the operation is finished.
•
File open error: The open file operation failed.
•
Out of Memory: The memory overflows.
•
Production mode isnʹt available for this chip: Since the production mode is
dependent on the pin check, the chips without pin check function are not
Applicable for production mode.
•
Cancel production mode : Cancel the production mode.
•
Too long file name: The file name is too long.
•
User cancel: The system displays this message after you select Cancel on the
Status bar.
•
Canʹt cancel!: The Cancel operation has failed.
•
Not a project file: The file selected is not a project file. After the software is
updated, the software may not be able to identify a previously created file.
You will need to create the file again.
Appendix
XELTEK periodically publishes upgrade software on the XELTEK website. You can
download and upgrade your software from the website. Non‐users may download
the software for evaluation.
Troubleshooting
If the User Manual does not answer your questions, first contact your sales agent or
the distributor. If you still need technical assistance you can call XELTEK between
Mon‐Fri 7:30AM‐12:00PM & 1:00PM ‐ 4:30PM (PST). Make sure you have your
product serial number before calling. Before contacting XELTEK, check the
54 / 56
Advertisement
