Advertisement
2.2 Hardware and Driver Installation
After you set up the software, you can install the hardware and driver. The following
procedure explains the installation process.
NOTE: Do not follow these steps below if you have not yet setup the software (see
section 2.1).
1. Make sure all other programs are closed during the installation process.
2. Connect the programmer module to the computer through the USB port.
3. Turn on the power switch of the programmer module.
When you connect the new hardware, the system initiates the New Hardware
Wizard, which locates the driver from the software you have just installed.
The system displays alerts one at a time, illustrated below. The alerts on your
system may be slightly different.
13 / 56
Advertisement
