Table of Contents
Advertisement
XELTEK Automatics
1.
System introduction
1.1. About this manual
This manual applies to SB02 & SB05 & SB05E & SB05X & SB05EX programming
systems.In addition to special instructions, this document is fully applicable to all the
systems.
1.2. Model comparison
Model
Maximum
programmer
Maximum
sockets
Nozzles
I/O
2.
System Operations
2.1. Installation
Please set the machine to a horizontal location and suspend the rolling wheel with a
height adjustment device.
The power plug should be connected to the I/F cable, please secure it in place.
2.2. Steps of power on/off
Power on：Visually check that the machine is in normal condition and turn on the
Power off：End the session and move the mechanic arms to the home point,then
2.3. Introduction for the applications
SB0xprogramming system consists of two parts ，the mechanic application SB0X and
the programming software SP7500.
SB0X
User Manual
SB02
SB05
SP7500
SP7500
4
16
1
tape&tube&tray
tape&tube&tray
switch to on state;
Waiting for the industrial computer ready;
Press the control buttons on the front panel, respectively, for the
system button and programmer control button;
Open the application SB0X and SP7500 to enter debugging or working
status.
Turn off the applications ,the industrial PC,the control button in turn.
Rev. 03 - 5th MAY 2020
SB05X
SP108X
8
6
32
48
4
4
tape&tube&tray
SB-02&05
User Manual
SB05E
SB05EX
SP7500
SP108X
4
4
16
32
2
2
tape&tube&tray
tape&tube&tray
XELTEK. 2019. All rights reserved.
4 of 200
Advertisement
Table of Contents
