Xeltek Superpro IS416 Series User Manual page 38

system opens the Fuse Buffer Edit window, illustrated below.
The data for editing is either 0 or 1. Refer to the data manual of the device and the
JEDEC to determine which of the following explanations for the data apply.
•
1 represents an intact fuse and 0 represents a blown fuse, or
•
1 represents a blown fuse and 0 represents an intact fuse
4.3.4 Device Configuration Word
Important: The device configuration word varies from device to device. Refer to the
device data manual for more information about the configuration words. Set the
configuration words according to the requirements of your target system. Otherwise,
you cannot use the device normally even if it is normal when preparing and verifying
the program. Some single-chip microcomputers allow special working modes, such as
the storage area mapping, the watchdog time, the clock, or the encryption. Set these
special modes through the Device Configuration Word option. The user files contain
the configuration words of some devices. When you load these files, the system
automatically loads the configuration words into the configuration word buffer.
However, you must select the configuration words for some devices manually.
38 / 56