Advertisement
may try to select Middle or Low speed to work. Sometimes the on-line
program is complex, the target boards of customer are various, so the
setting of Speed mode is important.
5: Delay time of power on/off
Most time don't care these values. But if the board of customer has
large electric capacity, Maybe it's need to wait long time to power on or
off. The engineers of XELTEK will tell customer how to set these delay
time if need to do.
6: Control signals before/after algorithm
Don't care these settings.
4.4.3 Buffer
The default programming method is to program the device from the start address to the
end address. However, you may choose to program only a part of the chip, such as with
most E/EPROM (FLASH) devices. (Double click on buffer name and set the range of
programming)
43 / 56
Advertisement
