Table of Contents
Advertisement
4
Software Configuration
I
NTRODUCTION
The following provides details on the software configuration of the
steps contained within this section for proper setup and configuration.
TOOLS REQUIRED
The following tools will be required for proper configuration of the system:
•
PC/Laptop
•
Ethernet cross-over cable, or other network connection to your
•
Standard web-browser such as Windows Edge, Mozilla Firefox, Apple Safari, or other.
•
NEXUS Series
•
24 V AC power source
CONNECTING TO A NEXUS SERIES DEVICE
The
NEXUS Series
on the primary Ethernet Port. Your laptop's network card must be configured in a manner where it may access
this IP network setting. Refer to your operating system documentation for details on how to configure your
network card.
See
Ethernet Settings
Note:
The secondary Ethernet Port (marked "Port D") is configured with a default IP address (
subnet mask (
255.255.255.0
port to gain access to the
Primary and Recovery ports should not be both connected at the same time – unplug the primary port when
connecting your laptop to the recovery port.
To use the recovery port:
•
Depending on your Operating System, set your Network Adaptor to the
in Windows, in
Settings
the default value).
•
You should now be able to reach
there. (If you have
•
Once recovery is complete, the
©ABB 2021 All Rights Reserved.
Subject to change without notice
WWW.CYLON.COM
License file pre-installed
device is shipped with a default IP address (
on page 30 for details on how to reconfigure
), so that if connectivity is lost on the primary
NEXUS Series
controller as described below and reset it.
>
set the
Network & Internet
http://192.168.1.250/
HTTPS
enabled, you can reach the target at
NEXUS Series
Software Configuration
NEXUS Series |
NEXUS Series
NEXUS Series
192.168.1.251
NEXUS Series
LAN
to
and
IP address
192.168.1.1
in a browser on your
https://192.168.1.250/
device must be rebooted.
hardware. Please follow the
device
) and subnet mask (
255.255.255.0
device IP Address.
192.168.1.250
port, you can use the secondary
IP
network. e.g.
192.168.1.0/24
to
Subnet Mask
255.255.255.0
PC
and proceed from
instead.)
)
) and
(i.e.
17
Advertisement
Table of Contents
