Designated Use - Festo CPX-CEC Electronic Manual

Contents and general instructions

Designated use

Festo P.BE−CPX−CEC−E N en 1004a
The type CPX−CEC/CPX−CEC−...
ented in this manual is intended exclusively for use in Festo
CPX terminals for installation in a machine or an automation
control system.
In combination with a CPX terminal, the CPX−CEC/CPX−CEC−...
is used for
controlling pneumatic and electric actuators (valves, out
put modules and motor controllers via CANopen)
interrogating electric sensor signals through the input
modules
communication via Ethernet.
The CPX terminal with the CPX−CEC/CPX−CEC−... may only be
used as follows:
as designated in industrial applications
without any modifications by the user. Only the conver
sions or modifications described in the documentation
supplied with the product are permitted
in faultless technical condition
only in combination with approved components
(e. g. valves, drive/displacement encoder combinations).
The limit values specified for pressures, temperatures, electri
cal data, torques etc. should be observed.
Please comply with the regulations of the workers' com
pensation insurance association, the German Technical Con
trol Board (TÜV) and the electrical requirements of the VDE or
the corresponding national and local safety regulations.
CoDeSys controller docum
V