Flush Mount, Fixed At Rear - Furuno MU-190 Operator's Manual

1. MOUNTING, WIRING
7. Set the cutouts of the hood (19) assembly to the knobs on the hood fixing plates (19).
Hood (19) Assembly
8. Press the top of the hood (19) assembly to set the knobs in the cutouts.
9. Set the hood (19) assembly with the knobs tightly (4 pcs.).
1.4

Flush Mount, Fixed at Rear

The flush mount, fixed at rear method requires the flush mount kit OP26-12 (option, see page vii).
1. Use the flush mounting template (supplied) to make a cutout in the mounting location.
2. Attach the flush mounting sponges
H 19 and V 19 to the back of the
monitor unit in the order shown in
the figure at right.
Knob (4 pcs.)
Hood Fixing Plate 19
Cutout (4 places)
Press
Press
Flush Mounting
Sponge H 19 for
top and bottom
5
Flush Mounting
Sponge V 19 for
left and right