Filter Preparation; Assembling The Filter System; Filter Paper Configuration - Dean MF90 Series Installation & Operation Manual

MF90 SERIES PORTABLE FILTRATION SYSTEMS
CHAPTER 3: FILTER PREPARATION

3.1 Assembling The Filter System

On initial installation and before each use, remove all loose parts from the filter, wash the filter pan
and all accessories in hot, soapy water and dry thoroughly.
Water or boil-out solution MUST not be allowed to drain into the filter pan or filter
system. Irreversible damage will result if water is allowed into the system, and the
The MF90 portable filtration system uses a filter support grid, one sheet of filter paper and a hold-
down ring to secure the filter paper in place.

3.1.1 Filter Paper Configuration

See illustration for proper assembly.
1. Filter Pan Cover
2. Hold-Down Ring
3. Filter Paper (one sheet)
4. Screen/Support Grid
5. Filter Pan Assembly
A. First, place the support grid in the bottom of filter pan.
B. Place one sheet of filter paper on top of the support grid. Be sure the paper covers the whole
filter pan bottom.
C. Position the hold-down ring on top of the filter paper and latch the hold-down ring and filter
paper securely against the filter pan bottom, forming a tight seal.
D. Sprinkle 8 ounces of filter powder over the filter paper, distributing the powder as evenly as
possible. If filtering a second frypot immediately after the first, add only 4 ounces of filter
powder for the second filtering.
E. Place the crumb catcher screen (if applicable) in the filter pan. Allow the crumb catcher screen
to rest on the top edges of the hold-down ring.
F. Place filter pan cover onto the filter pan assembly.
WARNING!
warranty will be voided.
4
5
3-1
2
3
1