MICRO-EPSILON colorCONTROL MFA-5 Instruction Manual page 33

Operation
Baud rate
Log file window
Storage window
CIE C. diagrams
Deviation for intensity
Deviation for
xy values
Don't allow any
changes ...
colorCONTROL MFA-5
Set the baud rate here. The baud rate is 115200 for the newer devices.
The log file is defined in this window. This section is not important for usual use. It
is only needed for error analysis for the MICRO-EPSILON LED Check program.
The storage locations for the test report file and sensor settings file are defined
here.
Different CIE color spaces can be selected using this window which are dis-
played on the start screen if the CIE color space has been selected using the
View pop-up menu.
A tolerance window is defined using these selection options which is taken into
account for the comparison tests of LEDs. The LED is assessed as good if the
test value is within the tolerance window of the reference value. The tolerances
for individual LEDs can also be changed in the Measurement settings win-
dow, see Chap. 5.2.4.
Behaves analogously to Deviation for intensity.
This checkbox is equivalent to a confirmation question if an xy offset should be
changed by the user via the List of Settings window. There is no possibility
to change the offset of an inspection point / color chip while the check mark is
set. The state of the checkbox is saved when the software is closed and adopted
again when the software is restarted.
Page 33