Maintenance; Uninstalling Tof/Taxi; Disposal - Cedes TOF/TaxI Installation And Operation Manual

Table of Contents

Available languages

TOF/Taxi

Detection area dimensions

are not as expected

If a problem persists, please contact your local CEDES representative. Visit www.cedes.com for contact data.

14. Maintenance

Although the TOF/Taxi does not need regular maintenance, a periodical functional check is strongly

recommended as follows:

Check the mounting position and detection area of the sensor.

Clean the optical window with a soft towel and a little soapy water.

NOTICE

Damage to the optical window

Never use any solvents, cleaners or mechanically abrasive

towels or high-pressure water to clean the sensor.

Using a screwdriver, carefully press the white

clip underneath the mounting plate to take off the

mounting bracket.

Important: The mounting bracket might become loose

after being taken off several times. Replacements

can be ordered from CEDES.

The TOF/Taxi should only be replaced if a similar protection device is installed. Disposal should be done

using the most up-to-date recycling technology according to local regulations and laws. There are no harmful

materials used in the design and manufacture of the sensor. Traces of such dangerous materials may be found

in the electronic components but not in quantities that are harmful.

Make sure the mounting bracket is mounted horizontally

Check the setting of DIP switch 1 (Mounting position)

Make sure wall blanking (DIP switch 3) is not

activated while testing the detection area

Check Pot 1 and Pot 2

Figure 25: Pressing the white clip releases the

mounting bracket

English

Table of Contents

Table of Contents