Carmanah G Series User Manual page 38

7. Push the light bar wires into the light bar connectors, following the color scheme as noted on the LEDs.
Mount the light bar so that the black and white wires are on the left side. This ensures that
the RRFB flash pattern, which must start on the left, is compliant with the FHWA
requirements.
8. Slide on light bar cover and secure with the four provided #8 screws.
Two additional #8 screws are provided to prevent vandals from twisting the light bar grossly out of
alignment. These anti-vandal screws are installed through slots in the inner bracket into tapped holes
in the outer bracket as shown below.
Carmanah Technologies Corp. | 250 Bay St, Victoria, BC V9A 3K5, Canada | 1.250.380.0052 |
G SERIES USER MANUAL
4.0 FIXTURE AND PUSH BUTTON INSTALLATION
customerservice@carmanah.com
38
| carmanahtraffic.com