Close Off Unused Cable Openings; Attach The Cable Cover; Fig. 13.7: Unused Cable Outlets Sealed Off With Blind Plugs; Fig. 13.8: Cable Cover Closed And Screwed Together - Advantech DLoG DLT-V7210 P Operating Instructions Manual

13.4.6.

Close off unused cable openings

Fig. 13.7: Unused cable outlets sealed off with blind plugs

13.4.7.

Attach the cable cover

NOTICE: Property damage
To prevent fluids or dust penetrating the DLT-V72 during ongoing operation, the cable compartment on
the device must be sealed using the corresponding cable cover. The protection class is only ensured if
the cable cover is properly installed.

Place the cable cover in the DLT-V72 housing slot.

Screw the thin headless screws loosely into the holes of the cable cover.

Then fully tighten the screws with 3 Nm torque.
Example for an attached cable cover:

Fig. 13.8: Cable cover closed and screwed together

DLT-V72 Operating Instructions V2.50

Close off all unused cable openings of the rubber seal using the
accompanying blind plugs so that they are sealed.
Electrical installation, cables, cable cover
95 / 121