7.
Connectors
7.1.
Connectors under the cable cover
Fig. 7.1: External connectors under the cable cover
Pin assignment
Power supply
1 x SMA (optional)
1 x RSMA (optional)
USB0, USB1, USB2, USB3
RJ45
COM1, COM2
7.1.1.
COM1 as a voltage source
The COM1 interface can optionally supply to externally connected equipment with +5 VDC.
The voltages are protected by internal fuses and may not exceed a continuous consumed current
of 1 A at 5 V.
Depending on the connected devices, the maximum current consumption may be significantly lower.
Using the "DLoG Config" tool, you can select whether +5 VDC or RI is output on pin 9 of COM1.
DLT-V72 Operating Instructions V2.50
12/24/48 VDC nominal
Remote WWAN antenna
Remote WLAN antenna
USB 2.0 interfaces (HI-SPEED™), bootable
Fused at 1.0 A per channel
ESD Level 4 protected (according to EN 61000-4-2)
LAN Ethernet 10/100/1000 MBit/s
Serial interfaces
Max. 115,200 Baud (16550A compatible, 16 byte FIFO),
supports EIA-232-E on external 9-pin D-Sub connection
ESD Level 4 protected (according to EN 61000-4-2)
Connectors
27 / 121