Parameter Lists - Danfoss FC 300 Series Programming Manual

Parameter Lists

4 Parameter Lists
FC Series
All = valid for FC 301 and FC 302 series
01 = valid for FC 301 only
02 = valid for FC 302 only
Changes during operation
"TRUE" means that the parameter can be changed while the
adjustable frequency drive is in operation, and "FALSE"
means that the adjustable frequency drive must be stopped
before a change can be made.
Conv. index 100 67
Conv. factor 1 1/60 1000000 100000
Data type Description
2 Integer 8
3 Integer 16
4 Integer 32
5 Unsigned 8
6 Unsigned 16
7 Unsigned 32
9 Visible String
33 Normalized value 2 bytes
35 Bit sequence of 16 Boolean variables
54 Time difference w/o date
FC 300 Programming Guide
6 5 4 3
10000 1000
®
MG.33.MA.22 - VLT is a registered Danfoss trademark
4-Set-up
'All set-ups': the parameter can be set individually in each of
the four set-ups, i.e., one single parameter can have four
different data values.
'1 set-up': the data value will be the same in all set-ups.
Conversion index
This number refers to a conversion figure used when writing
or reading by means of an adjustable frequency drive.
2 1 0 -1 -2
100 10 1 0.1 0.01
-3 -4 -5 -6
0.001 0.0001 0.00001 0.000001
Type
Int8
Int16
Int32
Uint8
Uint16
Uint32
VisStr
N2
V2
TimD
4-1
4 4