Step 3: Connect; Step 4: Power Up - Digi WR64 Hardware Reference Manual

Quick start

Step 3: Connect

a. If you intend to configure cellular at this time,
b. Attach antenna(s).
c. If you intend to configure Ethernet at this time, use an Ethernet cable to connect the WR64
WAN/ETH1 port to a hub with access to the Internet.
d. Use an Ethernet cable to connect the WR64 ETH2 port to your PC.

Step 4: Power up

a. Connect DC power.
Note If you need help understanding power requirements, see
Digi WR64 Hardware Reference
Laptop or personal computer
Use an Ethernet cable to connect your WR64 to a laptop or PC.
SIM card(s)
If you intend to configure cellular at this time, acquire SIM cards as needed. Note
the carrier, network APN (Access Point Name), and SIM pin (if any) for each card.
Smart phone or tablet
Optional: Use a smart phone or table to to automatically register your WR64 in
your Digi Remote Manager account and connect to your cellular network. See
Quick start using the Digi Remote Manager mobile app.
Install SIM cards.
Digi WR64 power
Step 3: Connect
connector.
7