YASKAWA D1000 Series Quick Start Manual page 8

1 Preface
Do not modify the circuitry of the unit and the filter module.
Failure to comply could result in damage to the unit and will void warranty.
Yaskawa is not responsible for any modification of the product made by the user. This product must not be modified.
Check all the wiring to ensure that all connections are correct after installing the unit and connecting any other
devices.
Failure to comply could result in damage to the unit.
To get the full performance life out of the electrolytic capacitors and circuit relays, refrain from switching the unit
power supply off and on more than once every 30 minutes.
If a fuse is blown or equipment for residual current monitoring/detection (RCM/RCD) is tripped, check the
wiring and the selection of the peripheral devices.
Contact your supplier if the cause cannot be identified after checking the above.
Do not restart the unit or immediately operate the peripheral devices if a fuse is blown or an RCD is tripped.
Check the wiring and the selection of peripheral devices to identify the cause.
Contact your supplier before restarting the unit or the peripheral devices if the cause cannot be identified.
Do not expose the unit to halogen group disinfectants.
Failure to comply may cause damage to the electrical components in the unit.
Do not pack the unit in wooden materials that have been fumigated or sterilized.
Do not sterilize the entire package after the product is packed.
Precautions for CE Low Voltage Directive Compliance
This drive has been tested according to European standard IEC/EN61800-5-1, and it fully complies with the Low Voltage
Directive.
Do not use converters in areas with pollution higher than severity 2 and overvoltage category 3 in accordance with
IEC/EN664.
Ground the neutral point of the main power supply for 400 V Class converters.
8
NOTICE
YASKAWA ELECTRIC TOEP C710656 06A YASKAWA Power Regenerative Converter - D1000 Quick Start Guide