PowerWalker VFI 10K CPH Manual page 35

3-4-3-6. Events
In Event pages, you can check the current events, history events and reset events.
1) Currents Events
When an event occurs, it will display alarm code in Current Events page. If events exceed more than one
page, press " " or "
2) History Events
The detailed event information is saved in history events. It can save up to 160 pages in history events. When
a warning occurs, it will display alarm code, alarm time and UPS mode. When a fault event occurs, it will
display fault code, alarm time/date and UPS operation mode. (Refer to Chapter 4 Troubleshooting)
3) Reset Events
It's necessary to enter Maintainer password to enter Reset Events page as shown below. Then, press "
" " button to choose "Yes" to clear all history events or "No" to cancel the reset action. The default
maintainer password is 0729.
" button to read other events.
Events:
Current Events
History Events
Reset Events
Events:
Current Events
History Events
Reset Events
→
Current Events:
Fault Events:
No Fault
Warning Events:
01:BatLow
02:BatOpen
→
History Events:
Fault: 10/160
01:Bus Start Fail
Warning:
01:BatLow
02:BatOpen
Bypass Mode
2018-04-20
11:16:33
→
→
34
" or