Set Up The Guide Bracket; Installing The Leaf - FAAC S800 ENC Instruction Manual

5.4 SET UP THE GUIDE BRACKET

RISKS
PERSONAL PROTECTIVE EQUIPMENT
!
The guide bracket is an important component for installation safety,
to guarantee the stability and control of the leaf during movement.
The guide bracket in the FAAC catalogue is designed for applications
with leaves up to the maximum weight and length indicated in the
Technical data.
When FAAC guide brackets are not used, the installer is responsible
for designing the bracket suitable for the applied loads, defining the
construction materials, thicknesses, sizes and surface anti-corrosion
treatments. Play between the leaf and bracket must be MAX 2 mm.
The welds made must be certified.
1. Set up the guide bracket (8 -1).
2. Position the grooved joint ( 8 -2).
 
The notch on the joint must be centred with the centreline of the bracket
and directed as shown in the figure.
When the bracket is placed on the box the joint must be centred on the
vertical rotation axis of the leaf ( 8 - 3).
3. Weld the entire circumference of the joint on the guide bracket
( 8 -4).

5.5 INSTALLING THE LEAF

RISKS
PERSONAL PROTECTIVE EQUIPMENT
1. Assemble the bush ( 9-1) in the foundation box, inserted in the
reference pin ( 9-2).
2. Assemble the guide bracket ( 9-3).
3. Assemble the leaf on the guide bracket ( 1 0 ) and anchor the
leaf to the upper hinge.
!
Play between the leaf and bracket must be MAX 2 mm.
DO NOT weld the guide bracket to the leaf.
4. Check that:
- the leaf resting on the bracket is perfectly horizontal (use the
spirit level)
- movement is smooth and with no friction along the entire stroke,
all the way to the external opening/closing stops (if present)
!
When moving it manually, slowly guide the leaf for its entire stroke,
do not push the leaf so it moves freely.
S800 ENC
1 4
3
3
1
2
11
2
8
9
10
532116 - Rev.A