Start-Up; Force Adjustment (By-Pass); Closure Of The Box; Final Operations - FAAC S800 ENC Instruction Manual

6. START-UP

RISKS
PERSONAL PROTECTIVE EQUIPMENT
F
Before setting up electrical connections, disconnect the power supply
of the automation. If the disconnecting switch is not visible, put up
a ''ATTENTION - Maintenance in progress'' sign.
1. Set up the electrical connections according to the instructions of
the electronic control board and the installed accessories.
Electric motor cable
yellow-green
blue
brown
black
2. Turn the mains power supply back on.
3. Switch the electronic board on according to the specific instruc-
tions. If the motor rotates the wrong way, disconnect the power
and swap the wires of phases 1 and 2.

6.1 FORCE ADJUSTMENT (BY-PASS)

RISKS
PERSONAL PROTECTIVE EQUIPMENT
!
Adjust the by-passes in accordance with the applicable standards
(EN 12445).
1. Remove the protective caps (1 7 -1).
2. Adjust the opening and closing force by actuating the automation
electrically and using the by-pass screw corresponding to the
manoeuvre in progress ( 1 7 A or B):
 
screw A = adjusts the force of clockwise leaf movement
screw B = adjusts the force of anticlockwise leaf movement
tighten to increase the force
loosen to decrease the force
3. Set the protective caps back in place ( 1 7 -1).

CLOSURE OF THE BOX

Close the cover of the box with the supplied screws ( 1 8 ).

6.2 FINAL OPERATIONS

1. Ensure that the forces generated by the leaf are within the limits
allowed by the standard. Use an impact curve gauge in ac-
cordance with standards EN 12453 and EN 12445. For countries
outside the EU, when there is no specific local standard, the force
must be less than 150 N static.
2. Ensure that the maximum manual moving force of the leaf is less
than 220 N.
3. Use appropriate signs to highlight the areas where residual risks
remain despite having implemented all safety measures.
4. Put up the ''DANGER: AUTOMATIC MOVEMENT'' sign on the gate
S800 ENC
earth
neutral
phase 1
phase 2

+

–
in a visible position.
5. Put up the CE marking on the gate.
6. Complete the EC Declaration of Conformity of the machine and
the system Logbook.
7. Provide the owner/operator of the automation with the EC Decla-
ration, the system Logbook with the maintenance schedule and
the user instructions of the automation.
SCREW
A adjusts the force of clockwise leaf movement (a)
B adjusts the force of anticlockwise leaf movement (b)
ADJUSTMENT

tighten to increase the force
+
 –
loosen to decrease the force
14
b a
a
b
1
532116 - Rev.A
A
B
17
8
18