IBM 3592 Maintenance Information page 36

Table 6: Supported TapeAlert flags. The No. column is presented in decimal format, not hexadecimal format.
(continued)
No. Flag Description
31 Hardware B This flag is set when the tape
drive fails its internal Power-On
Self-Test (POST), and is not
cleared until the drive is powered
OFF.
32 Interface This flag is set when the tape
drive detects a problem with the
fibre interface. It is cleared when
the drive is powered OFF, or a
successful microcode update is
completed.
33 Eject media This flag is set when a failure
occurs that requires the tape
cartridge to be ejected from the
drive and retried. The flag is
cleared when the cartridge is
ejected.
34 Download This flag is set when an FMR
fail image is unsuccessfully
downloaded to the tape drive
with the fibre or RS-422 (LDI)
interface. It is cleared when the
drive is powered OFF or a
successful microcode update is
completed.
36 Drive Drive temperature sensor
temperature indicates that the drive is too hot.
It is cleared when the drive is
powered off.
37 Drive voltage This flag is set when the drive
detects power supply voltages
outside of the specified voltage
limits. It is cleared when the
drive is powered OFF.
38 Predictive A hardware failure of the tape
failure drive is predicted.
39 Diagnostics This flag is set when a tape
required cartridge or drive FID or ATTN
DRV message is posted.
50 Lost Media statistics were lost at
statistics some time in the past.
16 IBM 3592 TS1140, TS1150, TS1155, and TS1160 Tape Drives: Maintenance Information
Customer action CE action
Call for Service. See Note 1.
Call for Service. See Note 1.
Try different media. Try different media. If problem
persists, go to "FID 87 or F2 -
Isolating fault between media
and hardware" on page 243.
Call for Service. Try microcode update
procedure again (see
"Microcode maintenance" on
page 217).
Call for Service. Go to "FID 85: Drive canister"
on page 252.
Call for Service. See Note 1.
When it is See Note 1.
convenient, call for
Service.
Call for Service. See Note 1.
No action that is None
required. Status
only.