IBM 3592 Maintenance Information page 29

Table 4: FIDs and FRUs (continued)
Reporte FRUs FRU name or description
d FID
84 or E6 Timing problem in the microcode or the electronics, or multiple check-1 errors occurred
83 Microcode
85 Drive canister
82 Power supply
EA Power supply cables
85 Read/write, or track-following error
87 Cartridge
85 Drive canister
86 or F2 Hardware or media fault
FID 87 or F2 that occurs while the Test Drive or Test Device diagnostic test is run, can be caused by
a drive that needs calibration. An automatic calibration step runs during the longer Test Device
diagnostic test. In addition, an automatic calibration step is run if the initial pass fails, during the
short Test Drive diagnostic test.
87 Tape Cartridge
85 Drive canister
87 or FE Cartridge problem
87 Tape cartridge
85 Drive canister
8A, D0, Degraded hardware - Customer jobs continue to run, but with degraded performance. Complete the
or D8 action, at your earliest convenience.
85 Drive canister
AA General configuration problem
- Configuration problem
- Invalid drive serial number
AC Worldwide ID is blank, is invalid, or cannot be read
85 Drive canister
Prob- Page reference or instruction
ability
50% "FID 84 or E6 - Isolating fault between
microcode and hardware" on page 240
40%
• "FID 85: Drive canister" on page 252
7% "Power problems MAP" on page 193
3%
• "FID EA: Cables FRU kit" on page 255
5% "FID 87 or F2 - Isolating fault between media
and hardware" on page 243
95%
• "FID 85: Drive canister" on page 252
50% "FID 87 or F2 - Isolating fault between media
and hardware" on page 243
50%
• "FID 85: Drive canister" on page 252
95% "FID 87 or F2 - Isolating fault between media
and hardware" on page 243
5%
• "FID 85: Drive canister" on page 252
100% • "FID 85: Drive canister" on page 252
90%
1. Reset drive
2. Go to "Installation checkout" on page 174.
10% Enter valid drive serial number. Go to "CE DRV
Ser No menu (CE Offline Mode)" on page 121.
- If you are installing a new drive, contact your
next level of support and report this problem. If it
is an existing drive, try to reenter the WWID (see
"Setting WW names" on page 208). Go to -
• "FID 85: Drive canister" on page 252
Start 9