Center The Control Surfaces - Hobbico Flyzone DC-3 Airliner Manual

CENTER THE CONTROL SURFACES

Aileron Aileron
Aligned with Aligned with
Wing Wing
Aileron Trim Aileron Trim
1. Before flight, center the aileron control surface with the
aileron trim adjustment.
Elevator Trim Elevator Trim
2. Before flight, center the elevator control surface with the
elevator trim adjustment.
Rudder Trim Rudder Trim
3. Before flight, center the rudder control surface with the
rudder trim adjustment.
4. To alter the center position of the aileron and elevator
control throws, follow these steps. Center the trim on the
transmitter, then unplug the battery from the model before
attempting to mechanically adjust the linkages.
Alter the Control Surface Center Position
REVERSE THE CONTROL THROWS
If you ever need to reverse the control throws, follow this
simple procedure.
Press and hold one of the
corresponding control
surface trim buttons and
cycle the power off and
then on to reverse any
control surface direction.
Hear a «Beep Beep Beep»
sound.
CAUTION: Unplug the battery in the model before
attempting to reverse the control throws.
ARM THE MOTORS
Keep hands and onlookers clear of propeller during
arming and operation.
1. Switch on the transmitter and position the throttle control
stick in the low or minimum position. Plug the battery into plane.
8