Advertisement

READ THESE
READ THESE
INSTRUCTIONS
INSTRUCTIONS
BEFORE
BEFORE FLYING !
Controller
3.7 V-150 mAh
WARNINGS
FOR YOUR SAFETY PLEASE
READ AND UNDERSTAND THESE
WARNINGS.
Radio control models are not toys.
Serious injury to people or damage to property
can result if they are not used in a responsible
manner.
Read all instructions carefully prior to
assembling and before flying this model. Seek
advice should any information be unclear. You
assume all risk and responsibility when using
this model.
GENERAL WARNINGS
Never fly your aircraft from the street or at night.
Always fly in an open area free of obstructions.
When flying, make sure any spectators are
behind you.
Always be conscious of the spinning propeller.
Be careful not to allow loose clothing to be drawn
into the propeller.
Because your aircraft is operated by radio control,
it is important to make sure you are always using
fresh and/or fully charged batteries. Never allow
the batteries to run low, or you could lose control
of the aircraft.
Do not allow any of the electrical components to
get wet, or electrical damage may occur.
You should complete a successful range check
of your radio equipment prior to each new day of
flying, or prior to the first flight of a repaired aircraft.
Do not use any solvents to clean your model.
Solvents will damage the foam and plastic.
Use a dry cloth to clean any dirt from outside
of the aircraft.
FLYING !
ITEMS INCLUDED
(4) AA Batteries
LiPo Battery
Voyager
This product includes small and sharp-edged
parts. Always assemble and keep this product
out of children's reach.
Do not fly your airplane on days with strong
winds or side winds.
When not using the model, always take the battery
out of the plane and switch off the transmitter.
Also, remove the batteries from the transmitter as
batteries may overheat or leak, causing damage.
Do not store this model in a high-temperature/
humidity area or in direct sunlight.
RADIO CONTROL
SYSTEM WARNINGS
Always turn on your transmitter before
turning on the aircraft and always
remove the battery from the aircraft
before turning off your transmitter.
Always unplug the flight battery when not flying
the aircraft.
Never shorten the receiver antenna, or you could
lose control of the aircraft during flight.
Never attempt to disassemble or modify any of
the radio control system components.
LIPO BATTERY WARNINGS
YOU MUST READ THIS BEFORE
CHARGING THE BATTERY
All instructions, warnings, and cautions must be
followed at all times. Failure to do so can lead to
serious injury or fire. Do NOT use this product
before reading and understanding all directions
and warnings.
Do NOT use or charge the battery if it is hot
or swollen.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Dromida Voyager DIDA0211 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Hobbico Dromida Voyager DIDA0211

  • Page 1 READ THESE READ THESE INSTRUCTIONS INSTRUCTIONS BEFORE BEFORE FLYING ! FLYING ! ITEMS INCLUDED Voyager (4) AA Batteries Controller 3.7 V-150 mAh LiPo Battery WARNINGS This product includes small and sharp-edged parts. Always assemble and keep this product FOR YOUR SAFETY PLEASE out of children’s reach.
  • Page 2: Install Transmitter Batteries

    Do NOT overcharge the LiPo flight battery. Maximum voltage INSTALL for each battery must be followed. TRANSMITTER BATTERIES Do NOT short-circuit the battery. Check polarity before connecting the battery to the charger. Remove the battery when it’s not in use. Do NOT operate or charge unattended.
  • Page 3: Transmitter Function

    TRANSMITTER FUNCTION Elevator Rudder...
  • Page 4: Installing The Wing

    Throttle PLUG IN THE FLIGHT BATTERY Turn on the transmitter. Move the throttle to 0%. Connect the matching plugs and install the battery in the recess, in the bottom of the plane. Set the plane next to the transmitter (within 3 ft. [1m]). The plane will link to the transmitter automatically.
  • Page 5 CHOOSING A FLYING FIELD TAKEOFF The Voyager can be flown indoors in an area the size of a basketball court or outdoors at a park. There should not be any vehicles, buildings, power lines, trees, large rocks, people or anything else that your model can crash into. Control may be lost 150 ft 150 ft...
  • Page 6: After Landing

    LANDING When your plane feels like it is beginning to lose power, it is time to land. AFTER LANDING MAKING REPAIRS For light weight and durability, the Voyager is made of foam. If it does break, repairs can be made using foam safe CA Always unplug and remove the plane’s battery first.
  • Page 7: Replacement Parts

    Adjust the bends if not enough trim is available. 3002 N. Apollo Drive, Suite 1 (217) 398-0007 Champaign, Il, 61822, U.S.A. hobbyservices@hobbico.com BATTERY RECYCLING ATTENTION: The Voyager is powered by a rechargeable LiPo battery. At the end of the battery’s useful life, under various state and local laws, it may be illegal to dispose of the battery Solution: Check the control linkages for damage.
  • Page 8: Fcc Statement

    This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. www.hobbico.com/ama-lipo-warning.html This equipment should be installed and operated with a minimum distance of 8 inches [20cm] between the radiator (transmitter) and your body. ® © 2016 Dromida, a Hobbico company dromida.com DIDA0211...

Table of Contents