Displaying Information About The Mobile Panel; Display Firmware - Siemens SIMATIC HMI Series Operating Instructions Manual

Parameterizing the Mobile Panel
5.8 General settings
5.8.10

Displaying information about the Mobile Panel

You can use this function to display device-specific information. You will need this
information when contacting Technical Support
(https://support.industry.siemens.com/cs/ww/en/).
Requirement
The Control Panel is open.
Procedure
1. Open the "OP Properties" dialog using the "OP" icon.
2. Change to the "Device" tab.
①
②
③
④
⑤
⑥
⑦
Device-specific information is displayed.
Note
The size of the flash memory does not correspond to the available memory for a project.
5.8.11

Display firmware

You can use this function to obtain information about the firmware on the HMI device. You
will need this information when contacting Technical Support (Page 268).
Requirement
The Control Panel is open.
118
HMI device name
Version of the HMI device image
Version of the bootloader
Bootloader release date
Size of the internal flash memory in which the HMI device image and project are stored
MAC address 1 of the HMI device
See "Restarting the HMI device (Page 101)."
Mobile Panels 2nd Generation
Operating Instructions, 09/2018, A5E33876626-AC