Parameterizing the Mobile Panel
5.7 Configuring operation
Requirement
● If you want to restore the factory settings: The HMI device is connected in accordance
with "Connecting a Configuring PC (Page 54)".
● PROFIsafe-based F-system: PROFIsafe communication was terminated.
● The Control Panel is open.
Procedure
1. Open the "OP Properties" dialog using the "OP" icon.
2. Change to the "Device" tab.
3. Click the "Reboot" button.
The following dialog appears:
①
②
4. Press one of the following buttons:
– "Reboot": Restart the HMI device immediately.
– "Prepare for Reset": Reset the HMI device to factory settings.
– "No": Do not perform a restart, close the dialog.
See also
Desktop and Start Center (Page 87)
102
Button for restart
Button for restoring factory settings and subsequent restart
Note
Press "Prepare for Reset" to delete the operating system and project data.
Restore the operating system as described in the section
"Reset to factory settings with ProSave (Page 198)".
Mobile Panels 2nd Generation
Operating Instructions, 09/2018, A5E33876626-AC